First: Add a small amount of 3M™ Famous Finish Compound onto a purple foam pad on the rotary polisher.
Polish in an overlapping pattern, RPM between 600 - 1500.

Note: The softer the coating, the lower the temperature and thus the RPM needs to be.
Wipe off any excess polish and inspect the area.

Second: Apply 3M™ Finish Control Spray, wipe off with microfiber cloth or 3M™ Polishing Cloth.

Third: Re-Polish the area to ensure a high gloss finish is achieved, with no additional compound onto the foam needed.
Wipe off any excess polish and inspect the area - most colours are fine now.
For critical colours (very dark or black) - remove the holograms with 3M™ Ultrafina SE and blue polishing pads.

Note: Using this process too dry will not give you swirl-free results! Don't apply too much pressure - just run the pad over the surface, covering the whole area generously.